How do I configure ADSL?

How do I configure ADSL?

How do I setup my ADSL router for Internet Access?

1. Type – Set the connection Type to PPPoA.
2. Name – Type in the name for theconnection.
3. Options – Enable the NAT and Firewalloptions.
4. Encapsulation – set to VC.
5. Username – Type in the ISP login username.
6. Password – Type in the login password.
7. Keep alive – leave default.

How do I download Cisco config?

Downloading Startup and Running Config Files from Cisco Devices

1. Click the Tools tab.
2. Choose Config File Manager available under the CISCO Tools category.
3. To configure SNMP properties click Settings located at the top right corner or click Admin -> Settings.
4. Enter the Device Name or its IP Address.

Where is Cisco running config?

RAM
There are two configurations stored in a Cisco router; the startup configuration is stored in nonvolatile RAM (NVRAM) and is only read when the router “starts” up; the other is the running configuration and it is stored in RAM while the router is operating.

What is PPPoE Cisco?

The Point-to-Point over Ethernet (PPPoE) is a network protocol for encapsulating PPP frames inside Ethernet frame. PPPoE combines Ethernet and PPP, to provide an authenticated method of assigning IP addresses to client systems.

How do I configure my ADSL modem manually?

1. Open up a web browser and type in theIP address of the DSL-300T (default is 192.168.
2. Enter the Login nameand password (default is admin/admin).
3. Click on the Setup tabat the top.
4. Configure the following for yourconnection:
5. Click on the Statustab at the top and then click on Connection Statuson the left side.

How do I configure my ADSL router as an access point?

How to setup a TP-Link DSL modem router as an Access Point?

1. Log into the router using tplinkmodem.net or the default IP address 192.168.
2. Click Advanced on the top navigation bar, then select Wireless on the left panel.
3. Click Advanced > Network > LAN > DHCP Server.

How do I read a Cisco config file?

Use the show running-config command to view the running configuration file. Use the show startup-config command to view the startup configuration file. You can configure a switch in the Cisco MDS 9000 Family by using configuration files you create or download from another switch.

How do I open a Cisco config file?

What is Cisco running config?

The running-configuration is the config that is in the router’s memory. You change this config when you make changes to the router. Keep in mind that config is not saved until you do a copy running-configuration startup-configuration. This command can be abbreviated sh run.

Where is PPPoE configured on a Cisco router?

Where is PPPoE configured on a Cisco router? The PPPoE configuration is applied to the dialer interface, not to the Ethernet interface. The dialer interface is linked to the Ethernet interface with the dialer-pool and pppoe-client commands.