To enter interface configuration mode, enter the interface configuration command. Interface configuration From global configuration mode, specify an interface by entering the interface command followed by an interface identification. To exit to privileged EXEC mode, enter the end command, or press Ctrl-Z.
Table of Contents
How do I go into router configuration mode?
To enter interface configuration mode, enter the interface configuration command. Interface configuration From global configuration mode, specify an interface by entering the interface command followed by an interface identification. To exit to privileged EXEC mode, enter the end command, or press Ctrl-Z.
What are the three modes of router configuration?
Cisco Router modes
- User execution mode – As soon as the interface up message appears and press enter, the router> prompt will pop up.
- Privileged mode –
- Global configuration mode –
- Interface configuration mode –
- ROMMON mode –
What is configuration mode?
Global Configuration mode mode allows users to modify the running system configuration. From the Privileged mode a user can move to configuration mode by running the “configure terminal” command from privileged mode. To exit configuration mode, the user can enter “end” command or press Ctrl-Z key combination.
What are the 4 types of mode in a router?
There are four operating modes in the router settings — the main mode and three additional modes:
- Router (A) — main mode;
- Adapter (B) — connect Ethernet devices to a Wi-Fi network;
- Repeater/Extender (C) — Wi-Fi extension;
- Access point/Extender (D) — expansion of the Wi-Fi area with Ethernet connection.
What are the types of configuration mode?
There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode. After an EXEC session is established, commands within Cisco IOS Software are hierarchically structured.
What does fastethernet0 0 mean?
FastEthernet/0 is up, line protocol is up: this means that the interface is physically up and that the protocol is operational. When you use Ethernet, the protocol is normally up unless you configured port-security or BPDU guard.
What is router mode?
Best answer: The difference between router mode and access point (AP) mode is that router mode handles your home network’s creation and deals with internet traffic. AP mode allows you to extend the reach of your wireless signal by acting as a relay with a few simple software changes.
How many modes does a router have?
The router has three command-line modes. There’s a User EXEC mode, the Privileged EXEC mode, and the Global Configuration mode. I’m going to show you each one of these modes as well as how to access them and what is available. First, the User EXEC mode, sometimes referred to simply as User mode.
What is the difference between user mode and Privileged mode?
User mode is used to just view the configurations of the router and Privileged mode is used to view all configurations on the router and also allow to change some less important configuration.
Why we need various types of modes on the router?
Configuration modes and submodes—There are many different configuration modes. Each of these makes changes to the device configuration. To ensure that those configuration changes are not lost if the router reboots, you must copy the running configuration to the startup configuration.
What does fa0 1 mean?
on a cisco switch ethernet interface fa 0/1 mean. fa means fast ethernet. 1 means interface 1.
What speed is fast Ethernet?
100 Mbps
Fast Ethernet (IEEE 802.3u) has a maximum data rate of 100 Mbps and is the first Ethernet standard created specifically to operate in a star wired bus topology.