How do I reset my DIRECTV Genie remote control?

-Press and hold mute and select until the light blinks. -After releasing mute and select, type the numbers “9, 8, 1” in that order. -You should see the light blink again on the remote after typing the above 3 numbers. -Your remote should now be factory reset.

How do I reset my DIRECTV Genie remote control?

-Press and hold mute and select until the light blinks. -After releasing mute and select, type the numbers “9, 8, 1” in that order. -You should see the light blink again on the remote after typing the above 3 numbers. -Your remote should now be factory reset.

Why would my DIRECTV remote stop working?

Check for Stuck Buttons The remote may stop working if one of the buttons has been left stuck in the pressed position. To resolve this, first check that the mode on the remote is set to DirecTV. Then, to check if the buttons are stuck, run your fingers over all the buttons. Now try the remote again.

How do I get my DIRECTV Genie remote to work?

Point the remote at your Genie HD DVR, Genie Mini, or Wireless Genie Mini. Press and hold the MUTE and ENTER buttons. Stop when the green light at the top of the remote blinks twice. When the TV screen displays Applying IR/RF setup, you are in RF mode and ready to program the remote.

How do I pair my directv remote to my TV?

Control sound bars and TVs

  1. Open DIRECTV STREAM on your TV device.
  2. Choose Settings and then System.
  3. Select Remote & Devices, then Program Your Remote.
  4. Choose the TV manufacturer or sound bar you want to add.
  5. Follow the prompts to finish up.

How do I reset my Genie 3 remote?

Press and hold the Up(+) Down (-) buttons at the same time, until both LEDs flash blue and go OFF. To erase all of the remote devices from other types of Genie® garage door openers, Press and hold the Learn Code Button until the LED stops blinking. Start at step 1 to reprogram your remotes.

How do I connect my DIRECTV to my Samsung TV?

Assuming it’s a HiDef Receiver or DVR, just connect an HDMI cable from the DirecTV DVR/Receiver to one of your Samsung TV’s HDMI Inputs. Select that Input on your Samsung and you should be good to go. There’s nothing to “upload”. It’s just like connecting a DVD Player or any other video device to your HDTV.

Why is my Genie remote not working?

Receiver and remote control reset If the buttons on your remote are not responding, try resetting the receiver and remote control. On most DIRECTV receivers, there is a red button on the side of the receiver or inside the access card door. Press and hold the red button until the receiver restarts.