How do you reset a Whirlpool dehumidifier?

Resetting Your Dehumidifier Disconnect the power cord from its electrical outlet and wait five minutes before plugging the dehumidifier back in. The appliance should reset, clearing any settings programmed into the controls. Set the controls and start the dehumidifier as normal.

How do you reset a Whirlpool dehumidifier?

Resetting Your Dehumidifier Disconnect the power cord from its electrical outlet and wait five minutes before plugging the dehumidifier back in. The appliance should reset, clearing any settings programmed into the controls. Set the controls and start the dehumidifier as normal.

Why is my Whirlpool dehumidifier not working?

If the control board is defective, the dehumidifier will not run. The humidity sensor monitors the level of moisture in the air. When the moisture level is too high, the contacts in the humidity sensor close to allow the dehumidifier to run. If the humidity sensor is defective, the dehumidifier will not run.

Is there a recall on Whirlpool dehumidifiers?

More than two million dehumidifiers were recalled by the U.S. Consumer Product Safety Commission, after they overheated and caused fires in 107 separate incidents….2 Million Dehumidifiers Recalled Due to Fire and Burn Hazards.

BRAND MODEL NUMBERS
Whirlpool WDH70EAPW
Whynter RPD-302W, RPD-503SP, RPD702WP

How do you clean a whirlpool dehumidifier?

see whether it needs cleaning.

  1. Turn off dehumidifier.
  2. Remove bucket.
  3. Pull filter down from below front louvers.
  4. Pull bottom edge of air filter toward you to clear the bottom of.
  5. Use a vacuum cleaner to clean air filter.
  6. Slide air filter up into the dehumidifier.
  7. Reinstall bucket.
  8. Turn on the dehumidifier.

How do you fix a dehumidifier that won’t turn on?

Dehumidifier: Why won’t my dehumidifier turn on?

  1. Replace the dehumidifier electronic control board.
  2. Replace the dehumidifier user interface control board.
  3. Replace the dehumidifier evaporator thermistor.
  4. Replace the dehumidifier humidistat.
  5. Replace the dehumidifier compressor.

How do I reset my dehumidifier?

Try resetting the dehumidifier by disconnecting power to the unit for 30 seconds and re-connecting the power. Then, set the control settings and see if the unit operates properly.

How do you fix a dehumidifier that won’t collect water?

If your dehumidifier is not collecting water, the unit is not operating properly: Try resetting the dehumidifier by disconnecting power to the unit for 30 seconds and re-connecting the power. Then, set the control settings and see if the unit operates properly.

Why is my dehumidifier not collecting water?

If your dehumidifier is not collecting water even though the room temperature is over 65 degrees Fahrenheit, there may be an issue with the capacitor in the compressor circuit. The compressor circulates refrigerant through the unit to remove moisture from the air, which collects in the bucket.

Which dehumidifier has been recalled?

Ivation, perfect aire, SuperClima, Whirlpool, and Whynter. The brand name, model number, and pint capacity are printed on the nameplate sticker on the back of the dehumidifier. Click here for images of the recalled products.

How do you fix a dehumidifier that will not collect water?

Where is the filter located on a dehumidifier?

Dehumidifiers have an air filter that cleans the air entering the unit. If the air filter is clogged, it can reduce the performance of the unit. The air filter is usually located behind the front grille and should be checked and cleaned regularly.