How do you test a Harley ignition switch?
Remove the dash and turn it upside down and take a look at the switch . Is the harness plugged into the switch? it’s a 3 wire connector . Test for voltage at the red wire , it should read battery volts .
Why does my Harley just click when I try to start it?
When you turn the key and the battery is dead, you hear the magnet trying to magnetize the gear which is what makes the clicking sound. If the battery doesn’t give enough power, that magnet doesn’t have enough power to turn the flywheel of the engine.
How do you test a motorcycle ignition switch?
Set the voltage meter at 12 volts and reconnect the red meter clip to the grey wire terminal. Turn the ignition key to the “On” position. If the meter shows a reading, the problem was a wire connection. The lack of a voltage reading or a reading substantially less than 12 volts indicates a faulty ignition switch.
How do you reset the tip sensor on a Harley Davidson?
To reset the system, upright the bike, set the “kill” button in the “run” position and cycle the ignition off, on then off. It’s also in the manual.
How do I know if my starter solenoid is bad on my motorcycle?
If you take a hard object like a hammer and tap the starter motor it will often times start up for you. If you hear some sort of strange clicking noise coming from your starter, is likely the starter solenoid going bad. Over time, this noise occurs as corrosion starts to appear.
How do I know if my starter relay is bad on my Harley?
Secure red jumper wire from the positive battery post to the yellow or red wire terminal on the starter relay. Listen for a clicking sound. This sound is the contact inside the starter relay. If you do not hear a click, the starter might be malfunctioning.
How do I know if my motorcycle ignition switch is bad?
These are the most common problems associated with a faulty ignition switch:
- Engine dies: This is one of the most common symptoms of a bad ignition switch.
- Engine won’t start: The ignition switch supplies power to starter motor, ignition system and engine controls.
What to do if your Harley Davidson won t start?
Battery is good but Harley won’t start Once you are sure that the battery is still okay, and that the starter is still working, it means you have passed the first hurdle. It’s therefore time for some troubleshooting. Check to see if the kickstand is malfunctioning, also check the interlock clutch/starter switch.
Why won’t my motorcycle start?
This is the first major reason you might be having a problem starting your bike. If you are experiencing a very dim light or if the light goes off when you turn on the ignition, it could be that your battery is dead. If the battery can no longer crank the starter and can no hold a charge for long, it’s due for replacement.
Why won’t my Harley start when the side stand is down?
Even corrosion inside the valve can clog it. Using a screwdriver or any other item to tap the petcock can help jostle loose the gunk. It’s important to have the petcock unclogged because it can turn on or off the gas flow. Yes, if the side stand is down, your Harley bike may have challenges starting.
How do I know if my bike starter is bad?
Some of the ways to tell if your starter is bad is if the bike starts intermittently, hearing a running sound from the starter port even when the engine is on, or the starter not starting at all. Another way to tell is if you hear a clicking sound that sounds strange from the starter. How can I force start my bike?