How much is a rear axle for a Jeep Wrangler?
Jeep Wrangler Axle Shaft Replacement Cost Estimate. The average cost for a Jeep Wrangler axle shaft replacement is between $948 and $1,003. Labor costs are estimated between $188 and $237 while parts are priced between $761 and $766.
What axles are in my Jeep JK?
All four-door JK Wrangler original owners do have Dana 44s under the rear end. Currently, if you have purchased the new JL Wrangler, you have Dana 30 front and Dana 35 rear axles, unless you specifically bought one with upgraded Dana 44s. All Rubicon JL owners have a Dana 44 front and rear axle.
What year Jeeps have Dana 44 axles?
In 2003, the highly anticipated Jeep Wrangler Rubicon rolled onto the scene with Dana 44 axles equipped with selectable air lockers. Though the TJ Dana 44s had advantages over the anemic Dana 30 and 35, it wasn’t until the 2007 release of the Jeep Wrangler JK that the Dana 44 as we knew it was all but reinvented.
Is a rear axle expensive?
The average to repair a front axle is $550 dollars. Rear axle repair costs run a little higher and average about $799 dollars. Your axle repair cost will depend on the type of vehicle, make and model of vehicle you drive.
How much does it cost to replace rear axle?
However, it’s possible that you’ll just need to repair your axle rather than replace it. This has a smaller price tag; repairing your front axle could cost between $550 and $740, and repairing your rear axle could cost between $480 and $550.
How do I know what rear axle I have in my Jeep?
The first thing to do is to identify the axle by cleaning the fill plug on the back cover. Look at the inscription of the plug to find out the style of the rear end. In this example, Rich has a “Dana” style rear end.
How do I know what rear axle I have?
It’s worth noting that rear axles can sometimes be positively identified by a casting number and date stamped on the differential cover or axle tube. However, road debris, dirt, grime, and general age can obscure these numbers.
What jeeps have Dana 44 axles?
1967–1973 Jeepster Commando and Commando.
How do you tell if you have a Dana 30 or 44?
The quickest way to tell is to look at the top of the steering knuckles where the Front End Housing is connected to the Knuckle. On a Dana 44 Model, you will see a large castle nut threaded onto a ball joint. For Dana 30 Models, you will see a king pin cap with four bolts threaded down into the top of the knuckle.
What’s the difference between a Dana 30 and Dana 44?
The only difference between the JK Dana 30 and Dana 44 is ring gear size, electronic locker, and bigger shafts. (even if she insists shaft size doesn’t matter…) You’re better off just starting with an aftermarket Dana 44 that is a “true 44”.
Does the Jeep Wrangler have a solid axle?
Wranglers are known to have a terrain capable and rugged drivetrain. The solid axle design paired with an incredible 4WD system, provides Jeeps with a high degree of versatility and durability.
What axle do I have in my Jeep?
Natethegreat569. I’m new to all of this mechanical techy stuff.
Is a Jeep Wrangler considered a truck?
Is a Jeep Wrangler considered a truck? Definitely not. A jeep wrangler cannot be considered a truck because it doesn’t come with a permanently open bed. However, the two types of vehicles find a common ground in that they’re generally designed for outdoor conditions.
How to replace ball joints on a Jeep Wrangler?
cbernal120. Everyone I need some advice I am far from mechanically inclined.