Where do you connect the CD-ROM audio cable?
Your CD-ROM should have at least two cables connected to it: a Molex power cable and an ATAPI / IDE or SATA cable. The IDE or SATA cable should also connect to the motherboard or another interface card, and the power cable should connect to the power supply.
Is a CD-ROM digital?
CD-ROM drives are read by optical means and use laser beams to read binary (digital) data that is encoded on little pits on the optical disc. The drive gives the data to a computer, which then processes it. The CD-ROM was popular thanks to its low cost and higher storage, as compared to the floppy disc.
Is a CD-ROM digital or analog?
CD-ROM drives convert audio CD data to analog and send it to the sound card and headphones. They also send audio CD data to the computer’s bus, which is known as “digital audio extraction.”
Do you have to install an audio wire on the CD-ROM drive?
The headphone jack uses the CD-ROM directly you don’t need to connect any CD-ROM audio cables to make this headphone connector to work. The audio cable from the CD to the sound card allows you to use the sound card amp and speakers to playback the sound from CD-ROM.
How do I connect my CD player to my computer?
You can use use the USB or optical cable from the PC’s output to use the DAC for playback of digital files from the PC or network, plugging it into the input section of your player.
Is a CD-ROM input or output?
Good examples of an Input/ Output device are a floppy diskette drive, CD-ROM and DVD-ROM units and a hard while some devices are considered only Input or Output devices, the typical devices for communication between computers are considered to be both Input and Output.
What is the audio system in a CD-ROM?
Audio system in CD-ROM is completely separate from PC sounds. When the computer tells CD-ROM to start playing audio CD then the CD-ROM starts playin git all by itself.
How do I connect a CD-ROM to a sound card?
The audio cable from the CD to the sound card allows you to use the sound card amp and speakers to playback the sound from CD-ROM. The audio cable just connect the line level audio output form the CD-ROM drive to one PC soundcard line level audio input dedicated to CD-ROM audio cable. Why there is problems with CD-ROM audio connections
What does a CD-ROM/sound card cable look like?
On most CD-ROM/Sound card, it is a small grey round 3 or 4 wire cable with colored wires and a small plastic connector on each end. This is not the large flat grey IDE connector cable!
How do I connect a CD-ROM drive to a PC?
The audio cable just connect the line level audio output form the CD-ROM drive to one PC soundcard line level audio input dedicated to CD-ROM audio cable. There is quite much variety in CD-ROM audio connectors used in PC market.